Drillpine.Biz Support Forum

When using NorCascade, it automatically displays the top level menu.

Is it possible to display the top two levels automatically and then have the cascade effect from level 2 down? Hope that make sense.

If you look at http://www.woodworkingcentreshop.co.uk I have the top level menu shown on the left column. There are two entries - "Product Range" and "Manufacturer". If you hover over either it displays the second level immediately below. I'd like that second level displayed all the time. Is that possible?

thanks

Andy[/url]

I'd like that second level displayed all the time. Is that possible?

The only way to do this would be to have several separate NorCascade menus operating. Each one being tweaked to start at a different sub-level in the Actinic section tree structure. A huge, complex and costly job.

OK - thanks for that Norman.

Perhaps I should explore other ways of achieving this.

Can Norcascade start at a lower level than the top level? I think I've seen that it can. But if I do that then I need to find some way of inserting the "Product Range" and "Manufacturer" labels in (which do not need to be clickable).



Or, if it can't start at a lower level, then perhaps I move all my subsections up to be sections - but I still need to find a way of inserting those labels at appropriate places.


Mmmmm. Needs some thought.

regards

Andy

Can Norcascade start at a lower level than the top level?

Yes. See viewtopic.php?t=222